In fact, whether it is production, processing or application, there will be reasons to destroy HDPE claras. HDPE claras shipped to the site should be neatly stacked and should not be stepped on the bellows. HDPE carat tube should be covered nicely to prevent sun and rain. Then what else should we pay attention to? The protection points of HDPE pipe fitting suppliers are described in detail below.
HDPE pipe should be straight and not diagonal cut. The method of HDPE carat pipe joint is: HDPE carat pipe joint should be outsourced with a length of 0.3m large carat pipe, the top of HDPE carat pipe should be semi-twisted, and there should be no gap between them. To better ensure there are no gaps in the middle, mark the ends of both joints. When you're done, wrap it tightly with tape to prevent leaks.
The HDPE tube should be positioned accurately, especially around the joints. The distance between HDPE claras is 0.5 meters, which is essential. 6. When the welded steel bar is close to the HDPE tube, some effective measures should be taken to prevent the HDPE tube from burning. If you accidentally damage the HDPE tube, use tape to wrap the burned area tightly.
Taking into account that the total number of HDPE pipes on the roof has been slowly decreasing, all areas in conflict with HDPE pipes should be prevented from being used. Do not discharge HDPE pipe when pouring concrete. Vibrator should not be hit by HDPE. Do not use two vibrators to vibrate the HDPE pipe. Especially when the amplitude material vibrates, it is strictly prohibited to make the rod vibrate for a prolonged time in the same part, and the vibration time shall not exceed 20 seconds.